Cisco Systems MEM-16F-RSP4+=

RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide

78-12288-02

Removing the RSP4+

Step 6 Use the RSP4+ handle to carefully pull it straight out of the slot, keeping your other hand under the

carrier to guide it. (See Figure 2.) Keep the RSP4+ parallel to the backplane. Avoidtouching the board

or any connector pins.

Step 7 Place the removed RSP4+ on an antistatic mat or foam pad for installation later in this procedure.

Figure 1 Ejector Levers and Captive Installation Screwson the RSP4+—Vertical Orientation Shown

H1482a

Processor module

slot

STOP!

on contact

Bottom ejector lever

Processor

module

carrier guide

Contents

Main RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide Introduction Objectives Contents Related Documentation Installation Requirements Software and Bootflash Prerequisites Tools and Parts Required Safety Guidelines Safety Warnings Regulatory Compliance and Safety Information Installation Warning Regulatory Compliance and Safety Information Electrical Equipment Guidelines Preventing Electrostatic Discharge Damage Wrist Strap Warning Overview Confirming the Bootflash Memory Size Removing the RSP4+ Page Removing the SIMM Figure 3 Location of SIMM on the RSP4+ the SIMM free of the clips. (See Figure 4.) Be careful not to break the clips on the SIMM connector. Figure 4 Releasing the SIMM Spring Clips Figure 5.) Installing the SIMM Page Installing the RSP4+ Loading and Configuring the Bootflash Image 16MB bootflash output: Step 4 Use theformat bootflash command to format the bootflash memory, as shown in the following example: Page Obtaining Documentation World Wide Web Documentation CD-ROM Ordering Documentation Documentation Feedback Obtaining Technical Assistance Cisco.com Technical Assistance Center Contacting TAC by Using the Cisco TAC Website Contacting TAC by Telephone