Cisco Systems MEM-16F-RSP4+= Removing the SIMM

RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide

78-12288-02

Removing the SIMM

Figure 2 Handling the RSP4+ During Removal and Installation

This completes the RSP4+ removal procedure.

Removing the SIMM

After removing the RSP4+ from the Cisco 7500 series router, remove the 8-MB SIMM, using the

following procedure.

Step 1 Positionthe RSP4+ so that the handle is away from you and the bus connector is toward you—opposite

of the position shown in Figure 2.

H1355a

Contents

Main RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide Introduction Objectives Contents Related Documentation Installation Requirements Software and Bootflash Prerequisites Tools and Parts Required Safety Guidelines Safety Warnings Regulatory Compliance and Safety Information Installation Warning Regulatory Compliance and Safety Information Electrical Equipment Guidelines Preventing Electrostatic Discharge Damage Wrist Strap Warning Overview Confirming the Bootflash Memory Size Removing the RSP4+ Page Removing the SIMM Figure 3 Location of SIMM on the RSP4+ the SIMM free of the clips. (See Figure 4.) Be careful not to break the clips on the SIMM connector. Figure 4 Releasing the SIMM Spring Clips Figure 5.) Installing the SIMM Page Installing the RSP4+ Loading and Configuring the Bootflash Image 16MB bootflash output: Step 4 Use theformat bootflash command to format the bootflash memory, as shown in the following example: Page Obtaining Documentation World Wide Web Documentation CD-ROM Ordering Documentation Documentation Feedback Obtaining Technical Assistance Cisco.com Technical Assistance Center Contacting TAC by Using the Cisco TAC Website Contacting TAC by Telephone