Installing the SP and RP Memory Upgrade Kit
Figure 9 | Clearing the EMI Gasket in a Vertical Slot Chassis |
Gap between the module EMI gasket and the module above it
1mm 
FAN
STATUS
Press left
Press left
o
o
INPUT FAN OUTPUT
FAIL
INPUT FAN OUTPUT
FAIL
SUPERVISOR | WS- SUP 72 |
720 |
|
WITH |
|
INTEGRATED |
|
SWITCH |
|
FABRIC |
|
. |
|
91530
c.Using the thumb and forefinger of each hand, grasp the two ejector levers, and exert a slight pressure to the left, deflecting it approximately 0.040 inches (1 mm) creating a small gap between the supervisor engine’s EMI gasket and the module adjacent to it. (See Figure 9.)
Note Do not exert too much pressure on the ejector levers because they will bend and be damaged.
d.While pressing down on the ejector levers, simultaneously close the levers to fully seat the supervisor engine in the backplane connector. The ejector levers are fully closed when they are flush with the module faceplate.
Supervisor Engine 720 Switch Processor and Route Processor Memory Installation Note
| 19 |
| |
|
|
