Cisco Systems How to Configure the Cisco NM-8AM-V2 and NM-16AM-V2 Network Modules, Purpose

Cisco NM-8AM-V2 and NM-16AM-V2 Analog Modem Network Modules with V.92

How to Configure the Cisco NM-8AM-V2 and NM-16AM-V2 Network Modules

How to Configure the Cisco NM-8AM-V2 and NM-16AM-V2 Network Modules

To configure the Cisco NM-8AM-V2 and NM-16AM-V2 network modules, perform the tasks listed below:

•Configuring the Modems for the Country of Deployment, page 5 (required)

•Verifying the Modem Configuration, page 6 (optional)

Configuring the Modems for the Country of Deployment

The Cisco NM-8AM-V2 and NM-16AM-V2 network modules are designed to customize their settings to the country in which they are deployed. To configure a modem for the country of deployment, perform this configuration task.

SUMMARY STEPS

1.enable

2.configure terminal

3.modem country smart_acf country-name

4.end

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	modem country smart_acf country-name	Sets the modem firmware to use settings for the country of
		deployment. See the table of country names in the “modem
	Example:	country smart_acf” section on page 10.
	Router(config)# modem country smart_acf usa
Step 4
	end	Exits global configuration mode and returns to privileged
		EXEC mode.
	Example:
	Router(config)# end

Cisco IOS Release 12.3(7)T

5