Cisco Systems OC-12/STM-14

CiscoIOS Software Configura tion for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card

Additional References

Cisco IOS Release 12.0(8)S

Contents

Main Cisco IOS Software Configuration for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card Contents Prerequisites for the 1-Port Channelized OC-12/STM-4 (DS3) Information About the 1-Port Channelized OC-12/STM-4 (DS3) How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Configuring the OC-12 Controller Page Configuring the DS3 Serial Interface Cisco Remote Connection Management Page Verifying Local and Remote DS3 Port Settings Selecting a DSU Mode Setting the Sending and Receiving Rate Configuring the DSU Bandwidth Range Enabling Payload Scrambling Using show Commands to Check System Status Page Use the show protocols command to display the global (system-wide) and interface-specific status (Remainder of displayed text omitted from example.) of any configured Level 3 protocol. Use the show running-config command to display the currently running configuration in RAM. Using Loopback Commands OC-12 Controller Loopback Mode DS3 Channel Loopback Mode Configuring DS3 Port BER Testing Checking Bit Errors Using a BERT Entering Errors in BER Tests Using show Commands to Verify BERT Configuration Page Configuration Examples for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card Figure 2 1-Port Channelized OC-12/STM-4 (DS3) Line Card I nteroperability Diagram Additional References Related Documents Technical Assistance