Connecting Cisco ISDN PRI Network Modules to the Network

Revised: May 1, 2008, OL-12811-01

This guide describes how to connect Cisco Integrated Services Digital Network (ISDN) Primary Rate Interface (PRI) network modules to your network. It contains the following sections:

Channelized T1/E1 PRI Network Modules with G.703, page 2

Channelized T1/ISDN PRI Network Modules, page 5

Channelized T1/ISDN PRI with CSU Network Modules, page 6

Channelized E1/ISDN PRI Balanced (120-Ohm) Network Modules, page 7

Channelized E1/ISDN PRI Unbalanced (75-Ohm) Network Modules, page 10

PRI Module LEDs, page 11

Online Insertion and Removal with a Cisco PRI Network Module (Cisco 3660 and Cisco 3745 Only), page 14

Upgrading ISDN PRI Network Modules, page 15

Related Documents, page 15

Obtaining Documentation, Obtaining Support, and Security Guidelines, page 16

Note Unless specifically identified, references to PRI modules in this chapter include all these network modules.

Note Do not install an ISDN BRI network module in the same chassis as an ISDN PRI network module, unless you are using Cisco IOS Release 11.3(3)T or later. Earlier Cisco IOS releases do not support this configuration.

CT1/PRI modules are available with or without a built-in channel service unit (CSU), and with one or two ports. CT1/PRI modules connect to an external CSU; CT1/PRI-CSU modules connect directly to the network. Each T1 module provides up to 24 virtual channels per T1 port. Each channel can be configured individually as a serial interface.

Americas Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Page 1
Image 1
Cisco Systems OL-12811-01 manual Connecting Cisco Isdn PRI Network Modules to the Network