Cisco Systems OL-6109-01 manual Adding a Guard to the Zone Remote Guard List, 4-10

Chapter 4 Zone Configuration

Zone Remote Guard List

This section contains the following procedures:

•Adding a Guard to the Zone Remote Guard List

•Removing a Guard from the Zone Remote Guard List

•Interactive Recommendations Mode

Adding a Guard to the Zone Remote Guard List

The user may add one or more Guards to the zone remote Guard list.

To add a remote Guard or Guards to the zone remote Guard list perform the following:

1.From the Zone command group level type the following:

admin@DETECTOR-conf-zone-<zone-name># remote-guard<remote-guard-address> [<description>]

Where:

–remote-guard-address—The desired remote Guard IP address.

–description—(Optional) The remote Guard description (a maximum of 63 characters).

2.Choose ENTER.

3.Repeat steps one and two as many times as required.

Below is an example of the remote-guardcommand implementation:

admin@DETECTOR-conf-zone-scannet# remote-guard 192.168.100.33 admin@DETECTOR-conf-zone-scannet#

Removing a Guard from the Zone Remote Guard List

The user may remove a Guard from the remote Guard list.

To remove a Guard from the remote Guard list perform the following:

1.From the Zone command group level type the following:

admin@DETECTOR-conf-zone-<zone-name># no remote-guard

<remote-guard-address>

	Cisco Traffic Anomaly Detector User Guide
4-10	OL-6109-01