Chapter 4 Zone Configuration
Basic Zone Configuration
Where
2.Choose ENTER. Below is an example of the zone command implementation:
Describing a Zone
The user may add a description to a zone for identification purposes.
To add a description to a zone perform the following:
1.From the Zone command level type the following:
Where string specifies a string that describes the zone. The string length is limited to a maximum of 80 characters.
2.Choose ENTER. Below is an example of the description command implementation:
for demonstration purposes
Note To modify a zone’s description repeat the zone description procedure. The new description overrides the former.
Defining the Zone IP Address
The user must define a zone IP address to enable the Detector to perform traffic learning and detection procedures.
To define the zone IP address perform the following:
1.From the Zone command level type the following:
Where:
–
|
| Cisco Traffic Anomaly Detector User Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|
