14
power supply, you can add a second power supply while the chassis runs. If you have two power
supplies installed, you can remove one of them without removing power from the chassis. Figure 2-10
displays the location of the power supplies in the Topspin 360.
Figure 2-10: Power Supply Modules
Install Power Supply Modules
To insert a power supply, perform the following steps:
1. Ground yourself appropriately.
2. Remove the blanking panel if one resides in the slot.
3. Remove the power supply module from any packaging.
4. Insert the power supply into an open slot such that the pull handle sits close to the blower module.
NOTE: The power supplies should be inserted in opposite directions of each other.
5. Press the power supply firmly into the chassis.
Power Supplies