Chapter 3
Advanced Configuration
Gateway This is the IP address of the gateway device that allows for contact between the Router and the remote network or host.
Interface This interface tells you whether the Destination IP Address is on the LAN & Wireless (Ethernet and wireless networks) or the WAN (Internet).
Click Show Routing Table to view the static routes you have already set up.
Advanced Routing > Routing Table
Routing Table
For each route, the Destination LAN IP address, Subnet Mask, Gateway, and Interface are displayed. Click Refresh to update the information. Click Close to exit this screen.
Click Save Settings to apply your changes, or click Cancel Changes to cancel your changes.
Wireless > Basic Wireless Settings
The basic settings for wireless networking are set on this screen.
There are two ways to configure the Router’s wireless network(s), manual and
Wireless Configuration To manually configure your wireless network, select Manual. Proceed to the “Basic Wireless Settings” section. To use
Wireless > Basic Wireless Settings
Basic Wireless Settings
Network Mode From this
Network Name (SSID) The SSID is the network name shared among all points in a wireless network. The SSID must be identical for all devices in the wireless network. It is
Radio Band For best performance in a network using
NOTE: If you select Auto - 20/40MHz Channel for the Radio Band setting, then
Wide Channel If you selected Auto - 20/40MHz Channel for the Radio Band setting, then this setting will be available for your primary
Standard Channel Select the channel for
RangePlus Wireless Router | 13 |