Installing the
•Slot 1 is reserved for the supervisor engine.
•Slot 2 can be used for a redundant supervisor engine if the supervisor engine in slot 1 fails.
•If a redundant supervisor engine is not required, slots 2 through 6 on the
•The empty slots require filler plates, which are blank
Removing the Module
This section describes how to remove an existing module from a Catalyst 6500 series switch chassis slot.
Caution During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself.
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments.
To remove a module from the chassis, perform these steps:
Step 1 Disconnect any network interface cables that are attached to the module.
Step 2 Verify that the captive installation screws on all of the modules in the chassis are tight.
This step assures that the space that is created by the removed module is maintained.
Note If the captive installation screws are loose, the electromagnetic interference (EMI) gaskets on the installed modules will push the modules toward the open slot, reducing the opening size and making it difficult to install the replacement module.
Step 3 Loosen the two captive installation screws on the module.
Step 4 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the following sets of substeps:
Horizontal slots
a.Place your thumbs on the left and right ejector levers, and simultaneously rotate the levers outward to unseat the module from the backplane connector.
b.Grasp the front edge of the module, and slide the module part of the way out of the slot. Place your other hand under the module to support the weight of the module. Do not touch the module circuitry.
Vertical slots
a.Place your thumbs on the ejector levers that are located at the top and bottom of the module, and simultaneously rotate the levers outward to unseat the module from the backplane connector.
b.Grasp the edges of the module, and slide the module straight out of the slot. Do not touch the module circuitry.
Step 5 Place the module on an antistatic mat or antistatic foam, or immediately reinstall it in another slot.
Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note
| 13 |
| |
|
|
