4

Remarks: Freely programmable stop-function

Before starting a program it is possible to preprogram a time stop in every program segment. This function permits special additional functions like adding bleach or extra detergent to the wash bath.

Programming:

After selecting the program, press the ECO-button (E) and keep it depressed .

Now push the START-button (S) simultaneously and release same. Only now release the ECO-button (E).

The left display now shows “StO” (Stop) and the right display shows the program number. The first program sequence LED is switched on. Confirm by pressing the START-button (S) if a time stop is required in this phase of the program. If no time stop is needed, press the ECO-button (E) to move on to the next segment of the program. Run through the entire program in this way. If needed, return to previous segments by pressing the SELECT- button (P).

Errors can be corrected by returning to the erroneously programmed time stop in the segment and correcting by pressing the START-button (S).

After the final program segment all programmed time stops will be displayed and the left display will show “End”. Confirm this program by pressing the START-button (S) again. Now start the program.

Operation:

When a stop is reached during the run of the program, the time will be stopped. The wash bath will be filled to the appropriate level and temperature and the programmed wash action is executed.

The left display will alternately show temperature and “StO”, while the central display is showing “F1”. Now, if so desired, additional detergents can be added.

When this has been done, press the START-button (S) to continue the run of the program. To remove any possible remains of corrosive products in the tub, the machine will rinse an additional 2 seconds.

Programmable automatic start

By using this function a program can be started up to 99 hours later.

Programming:

After selecting the program, press the SELECT-button (P) again and keep it

depressed.

Now push the START-button (S) simultaneously and release same. Only now release the SELECT-button (P).

The left display now shows “DEL” (Delay). The central display shows “10” (minutes). Every push on the SELECT-button (P) will add 10 minutes to the delayed start time. Hours and minutes are separated by a decimal point: 1.5 stands for 1 hour and 50 minutes. After 10, the counting is done by hours.

By pressing the ECO-button (E), the delay time can be counted down.

Operation:

After having set the desired delay time, the count-down can be started by pressing the START-button (S). During the count-down the displays blink and the remaining time is counted down. In the last hour the displays blink faster. When the delay time has elapsed, the program is started automatically.

19