Citizen CT-S281 manual 29

5.2 Manual Setting of Memory Switch

Memory switches can be set manually or by a command. For manual setting, refer to the next page.

The function of each memory switch is shown in the following table. (The white-on-black characters are factory setting.)

Switch No.	Setting			0 (OFF)		1 (ON)
Memory SW1-1	Power ON Info					Not Send
					Valid
SW1-2	Buffer Size	4k bytes				45 bytes
SW1-3	Busy Condition			Full/Err				Full
SW1-4	Receive Error					No Print
		Print “?”
SW1-5	CR Mode							LF
			Ignored
SW1-6	Reserved
					Fixed			−
SW1-7	DSR Signal							Valid
				Invalid
SW1-8	Reserved
					Fixed			−
Memory SW2-1	Reserved
					−		Fixed
SW2-2	Auto Cutter			Invalid				Valid
SW2-3	Spool Print							Valid
				Invalid
SW2-4	Full Col Print	LineFeed				WaitData
SW2-5	Resume aft PE				Next			Top
SW2-6	Reserved				−		Fixed
SW2-7	Reserved				Fixed			−
SW2-8	PNE Sensor				Valid	*
							Invalid
Memory SW3-1	Resume Cttr Err				Valid	Invalid
SW3-2	Reserved				Fixed			−
SW3-3	Reserved				−		Fixed
SW3-4	Reserved				Fixed			−
SW3-5	Reserved				Fixed			−
SW3-6	Reserved				Fixed			−
SW3-7	CBM-270 Mode			Invalid				Valid
SW3-8	Resume Open Err				Close	Command
Memory SW4-1	Reserved				Fixed			−
SW4-2	Reserved				Fixed			−
SW4-3	Feed&Cut at TOF			Invalid				Valid
SW4-4	Reserved				Fixed			−
SW4-5	Reserved				Fixed			−
SW4-6	Reserved				Fixed			−
SW4-7	Reserved				Fixed			−
SW4-8	Partial Only			Invalid				Valid
*Factory option

— 26 —