6.Saving the setting and exiting the memory switch setting mode

Press the FEED button shortly to move to “Write/Factory Setting”. Then press and hold the FEED button. The printer prints the content of new setting and exits the memory switch setting mode to return to the normal standby state.

*Unless saving the setting is executed, the changed setting cannot be enabled.

7.Initializing the memory switch

When you want to return the memory switch setting to the initial state, go to “Write/Factory Setting” in the above procedure. Here, open the paper cover and press and hold the FEED button till buzzer sounds. This allows the printer to return to the initial state.

*All the memory switches settings are returned to the factory set values.

5.3 Printing Paper

Use the print paper shown in the following table or the paper with equivalent quality.

Paper Type

Product Name

Recommended thermal

TF50KS-E2D, TF77KS-EY from Nippon Paper

paper roll

PD160R from Ohji Paper

 

F230AA, PB670 (2-color) from Mitsubishi Paper

 

(Unit: millimeter)

Paper width 58 −+01

Printing surface

Maximum print area 48

 

φ83 or less

D

d

Paper thickness t (∝m)

d

D

60∝m≦t≦75∝m

φ12

φ18

75∝m＜t≦100∝m

φ25.4

φ32

CAUTION!

Use the paper with the start of winding to roll core is as shown below.

●No fold line is present and paper is along the inner diameter.

●No turnup is present.

●No pasting to core is present.

●Outer winding (print side out) is used.

— 29 —