2-4
2.4 Printer Se tup Mode
To enter the Printer Setup Mode, press and hold down the Pause key then press
the Feed key and release both keys. In a few seconds you will hear a beep and
see Transfer or DirectTM displayed on the LCD screen. The functions of the
control keys are described below.
Changes to the printer configuration are stored in nonvolatile memory. T his
guarantees that the printer configuration is maintained even after the power is
turned off.
[Functions]
Print mode selection, peeling sensor ON/OFF, auto-cutter ON/OFF, etc.
n Pause key: Selects the mode.
n Feed key: Selects the mode item.
n Sto p key: Saves settings and returns the printer to normal operating mode.
Mode item Indication
¯
¯¯
¯
Direct-thermal/thermal Transfer ® Direct TM ®
transfer printing
¯
¯¯
¯
Peeling sensor Peel OFF ® Peel ON ®
¯
¯¯
¯
Auto-cutter Cut OFF® Cut ON ®
¯
¯¯
¯
Tearing Tear OFF ® Tear ON ®
¯
¯¯
¯
Sensor selectio n Edge ® Reflect ® Cont inuP ®
2.5 Self-Test Mode
The printer can be placed into self-test mode by pressing and holding the Feed key
while turning the printer on.
Note: Proper use of this mode requires a minimum label size of 4” x 4”. Use of
a smaller label will prevent the user from seeing all printed information,
and verifying the print quality across the entire print head.