6-18
･ Initializatio n parameter values
Initialization values for print or cut position are described below by each
operating mode.
In Native ON
Unit: mm ( inch)
Norma l
print Auto-cutter Peeling Tear-off M inimum
value
Print position
(Onnnn, form
offset)
55.9(2.2) 55.9(2.2) 55.9(2.2) 55.9 (2.2) 12.7(0.5)
Cut pos i tion ( fnnn,
feed offset) 55.9(2.2) 86.4
(3.4) 68.6
(2.7) 73.7
(2.9) 12.7
(0.5)
If value lower than the minimum value is set, the initialization value will be set
automatically.
6.5.6 When "fnnn" command is executed while Tear is OFF
Even with the tear-off OFF, the paper will be fed to the "fnnn"-spe cifi ed po sitio n
afte r printi ng if an "fnnn > Onnnn" value is set by usi ng the "f nnn" co mmand.
This function can be used in such cases as another device is incorporated in the
printer.
6.5.7 Priority order
The following three functions (optional) cannot be performed simultaneously.
If commands for those three functions are received s imultaneously, they will be
executed in the following priority:
1st: Auto-cutting
2nd: Peeling
3rd: Tear-off