Clarion compact disc manual Turning on and off the monitor, Mute, Adjusting the balance, English

While driving, keep the volume to a level at which external sounds can be heard.

Turning on and off the monitor

Each time you press the MONI button 25 , the monitor is turned on and off.

*While using the rear vision camera, monitor-off mode is canceled. When a button other than the ENT button 11 , the TAPE button 1 , SLOPE but- ton 2 , or CD button 3 is pressed, monitor-off mode is canceled.

Mute

Each time you press (center) of the ENT button 11 , mute is turned on and off.

“MUTE” is displayed when mute is turned on in radio mode, and “PAUSE” is displayed in tape, CD or CD changer mode.

Adjusting the balance

1)Press the A-M button 6 to go to the BAL- ANCE display.

Balance of the front

and rear speakers

Balance of the left and right speakers

CAUTION

•If no setting is made 5 seconds after pressing the A- M button 6 , the unit returns to the previous mode.

2)Slide the Up/Down button 11 to (left),

(right), (up), or (down) to adjust the balance of the speakers.

: Increases the volume of the left speaker.

: Increases the volume of the right speaker.

: Increases the volume of the front speaker.

: Increases the volume of the rear speaker.

3)Press the A-M button 6 to return to the pre- vious mode.

*The tone is adjusted with the equalizer. For information on equalizer operation, see the section “Operating the Equalizer.”

Adjusting the operation panel to a good viewing angle

Adjust the operation panel to an appropriate angle to watch the display and operate the buttons.

SLOPE button 2	CD Insertion slot 31
		English
Insertion slot 30 or the CD Insertion slot 31 .		Owner’s
Do not place foreign objects in the Cassette		Guide
ful not to let your fingers get caught in the panel.
When adjusting the angle of the panel, be care-

1)While the SLOPE button 2 is held down, the operation panel tilts.

If you press and hold the SLOPE button 2 , the panel turns upward to the maximum angle and stops.

2)When the operation panel is set to the maxi- mum angle, pressing the SLOPE button 2 closes the panel.

*The operation panel angle can be stored. For details, see the next subsection.

Notes:

•Do not place any object on the operation panel.

•Do not expose the operation panel to shocks.

Storing the operation panel angle

When the operation panel angle is stored, it is set to that angle after a CD or cassette tape is inserted.

1)Press the SLOPE button 2 to set an appro- priate operation panel angle.

2)Press the ADJ button 10 to go to the CON- FIGURATION display.

3) Slide the Up/Down button 11 to (up) or

(down) to move the cursor to “VIEW

ANGLE.”

4) Press (center) of the ENT button 11 .

15