English
8CZ209
Inserting the Battery
1Slide remote control unit’s rear cover in the
direction shown.
2Insert battery (CR2025) into insertion guides
with printed side (+) up.
3Press battery into compartment as shown.
4Replace and slide cover until it clicks into
place.
Notes:
Misuse may result in battery rupture and fluid
leakage, resulting in personal injury or damage.
Always follow these safety precautions:
•Use only the designated battery.
•When replacing the batte ry, insert with +/–
polarities correctly oriented.
•Do not subject battery to heat, or dispose in fire
or water. Do not attempt to disassemble the
battery.
•Dispose of used bat teries properly.
Note:
•Refer to the diagr ams in “3. CONTROLS”
(page5) when reading this chapter.
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power or car’s ignition
key. The unit remembers its last volume
setting.
Turning power on/off
1. Press the [SRC] button to turn on power.
2. Press and hold the [SRC] button (1 sec.) t o
turn off power.
Selecting modes
1. Press the [SRC] button to change ope ration
mode.
2. Each time t he [SRC] button is pressed, the
operation mode changes as follows:
Radio ➜ CD/MP3/WMA ➜ USB/iPod ➜ AUX
➜ Radio...
An iPod can be connected via a USB cable.
Adjusting the volume
1. Turn the [ ROTARY] knob clockwise to
increase volume; turn counterclockwise to
decrease volume.
∗Volume range is 0 (minimum) to 33 (maximum).
Switching the display
Press the [DISP] button to select desired
display.
C
R
2
0
2
5