Philips NV-GS120EB operating instructions Remote Controller, Inserting a Button-type Battery

Before Use

(88)Clip

≥Insert the plug securely into the [REMOTE]

Socket as far as it will goes. A loose connection will spoil normal operation.

The Remote Controller

ªInserting a Button-type Battery

Before using the Remote Controller, insert the supplied button-type battery.

1 While pressing the Stopper 1, pull out the Battery Holder.

ªUsing the Remote Controller

1Direct the Remote Controller at the Remote Control Sensor (29) of the Movie Camera and press an appropriate button.

	10˚
15˚	(29)
	15˚
	15˚

1

2Insert the button-type battery with the (i) marking facing upward.

3Insert the Battery Holder into the Remote Controller.

≥When the button-type battery is exhausted, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.)

≥Make sure to match the poles correctly when inserting the battery.

WARNING

“THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBER CR2025

MANUFACTURED BY PANASONIC). IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE. IT MUST THEREFORE ONLY BE FITTED IN EQUIPMENT DESIGNED SPECIFICALLY FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE AND MANUFACTURER. THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE ORIGINAL BATTERY, WITH THE CORRECT POLARITY CONNECTIONS OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT FOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED OF IN WASTE PRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION.”

≥Distance from the Movie Camera: Within approximately 5 metres

≥Angle: Within approximately 10o in the upward, and 15o in the downward and horizontal directions from the central axis

≥The above operating ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.

≥Within a 1-metre range, you can also use the Remote Controller on the LCD Monitor side of the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and that of the Remote Controller do not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [INITIAL] Sub-Menu to the desired Remote Controller Mode. (-17-)

Setup on the Remote Controller:

	6	1	5
2	STILL ADV PAUSE STILL ADV			1
	E	;	D
	INDEX	STOP	INDEX	P.B. ZOOM
	K	∫	L

SELECT

[VCR1]:

Press the [D] Button and [∫] Button simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button simultaneously. 2

≥When the battery in the Remote Controller is replaced, the mode is automatically reset to [VCR1] Mode.

-9-