Before Use
-10-
Power SupplyªUsing the AC Adaptor
1Connect the DC Input Lead to the Movie
Camera.
2Connect the DC Input Lead to the AC
Adaptor.
3Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown 1.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
ªUsing the Battery
Before use, fully charge the Battery.
≥We recommend using Panasonic’s Battery.
≥We cannot guarantee the quality of this Movie
Camera when batteries of other companies are
used.
1Attach the Battery to the AC Adaptor and
charge it.
≥Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
≥When charging the overdischarged battery,
the [CHARGE] Lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
1
the [CHARGE] Lamp blinks and the charging
time becomes longer than usual.
2Attach the charged Battery to the Movie
Camera.
Disconnecting the Power Source
Set the [OFF/ON] Switch (43) to [OFF] and, while
pressing the [PUSHB ATT] Button (50), slide the
Battery or DC Input Lead upward to disconnect it.
≥For other notes concerning this item, see -56-.
PUSH
BATT
ON
OFF
(50)
(43)
120.200B.book 10 ページ ２００４年２月２５日 水曜日 午後４時０分