![6. WIRING TECHNIQUES](/images/new-backgrounds/14529/1452921x1.webp)
6. WIRING TECHNIQUES
Name of Parts
English
*The factory default setting is SLAVE position.
SLAVE STAND
ALONE
1CeNET connectors
Connect to center unit using CeNET cable.
2Front RCA output connectors
Connect to external power amplifier using RCA pin cable.
3Rear RCA output connectors
Connect to external power amplifier using RCA pin cable.
4
5Center speaker RCA output connectors Connect to external power amplifier using RCA pin cable.
6Digital input connector
Connect to DVD/CD changer using optical digital cable (sold separately or included).
*Connect to black connector side
7Cable clip hole
Insert cable clip to hold optical digital cable in place.
8RESET switch
Press to reset circuitry if no sound is produced.
Note:
•Be sure the CeNET cable is connected when pressing the [RESET] switch.
Use When Connecting Optional Control Unit (DVC920)
9
•Set to STAND ALONE when connecting a control unit.
•Leave at SLAVE position when no control unit is connected.
0Analog input connectors (RCA) Connect to center unit’s RCA 2ch output.
Note:
•The following are enabled only when a control unit is connected.
!Control unit 8P mini DIN plug Connect to control unit.
@Control unit power connector Connect control unit’s power cable here.
*Leave tape in place when not in use.
DVH940 11