Clarion DVH940N owner manual How to Wire This Unit, English

How to Wire This Unit

English

Perform the settings and connections in the order indicated by the drawing below.

CAUTION

Throughout the process of wiring this unit, disconnect the negative (–) terminal of your automobile’s battery, and leave it disconnected until completely finished. Handling wires while the terminal is connected could result in dangero electrical shock or injury if an scccidental short circuit shoud occur.

1 CeNET Cable

•To connect a CeNET cable, hold it with the connector facing as shown, and insert securely.

•When disconnecting a CeNET cable, grasp the slide cap and squeeze gently.

2 Optical Digital Cable

•Insert the black connector securely into the digital signal input connector until it locks. The cable clip can be used to secure up to two optical digital cables.

•When disconnecting a optical digital cable, squeeze the tabs at the right and left sides of the connector, and pull gently.

Note:

•The optical digital cable should not be bent with a gentle arc radius of 1.5 cm or less. If it is bent sharper than this, the performance of the cable will be greatly reduced and the cable may be damaged.

3 RCA Pin Cable

•When connecting an RCA pin cable, be sure to confirm the source of the connection first.

4 [RESET] switch

•Following completion of wiring, press the [RESET] switch to return to default settings.

CeNET connector

Sliding cap

CeNET cable

Note:

•Route the CeNET cable with plenty of extra room so that the connector will not become disconnected accidentally.

Optical Digital cable (black connection)

Cable clip

Squeeze right/ left tabs

Note:

•Always turn the main [POWER] switch [OFF] before connecting or disconnecting digital fiber- optic cables.

12 DVH940