Clarion DXZ379RMP, DXZ378RMP Operations Common to Each Mode

Operations Common to Each Mode

English

To change adjustment setting

1.Press and hold the [DISP] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [x] or [v] button to select the “item name”.

“CONTRAST” ↔ “ILLUMI” ↔ “SCRN SVR” ↔ “MESSAGE INPUT” ↔ “SCROLL” ↔ “DIMMER” ↔ “BLINK LED” ↔ “A-CANCEL”↔ “TEL-SEL”↔ “TEL- SP” ↔ “TEL-SW”↔ “SYSTEM CHECK”

3.Press the [w] or [z] button to select the “desired setting value”.

∗ In the case of display blinking “ENT”, you

can press the [ ] button to adjust the setting value.

∗ After completing settings, press the [DISP] button to return to the previous mode.

●Setting the contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “10”. (Adjustment level: 1 to 16)

2-1. Select “CONTRAST”.

3-1. Press the [w] or [z] button to adjust the contrast.

●Setting the button and the display

illumination (DXZ379RMP only)

∗The factory default setting is “AMBER”.

2-1. Select “ILLUMI”.

3-1. Press the [w] or [z] button to select “GREEN” or “AMBER”.

●Turning the screen saver function on

or off

This unit is provided with the screen saver function which allows you to show various kinds of patterns and characters in the operation status indication area of the display in a random order. You can turn on or off this function. If the button operation is performed with the screen saver function on, the operation display corresponding to the button operation is shown for about 30 seconds and the display returns to the screen saver display.

∗The factory default setting is “ON”.

2-1. Select “SCRN SVR”.

3-1. Press the [w] or [z] button to select the setting.

Each time you press the [w] or [z] button, the setting changes in the following order:

“MESSAGE” ↔ “ON” ↔ “OFF”

●Entering message information

Message up to 30 characters long can be stored in memory and displayed as a type of screen saver setting.

∗The factory default setting is “WELCOME TO CLARION”.

2-1. Select “MESSAGE INPUT”.

3-1. Press the [ ] button.

3-2. Press and hold the [BND] button for 1 second or longer to clear the old message.

3-3. Press the [x] or [v] button to move the cursor.

3-4. Press the [BND] button to select a character type. Each time you press the [BND] button, the character type changes in the following order:

Capital letters ➜ Numbers ➜ Symbols ➜ Umlaut ➜ Capital letters…

3-5. Press the [w] or [z] button to select the desired character.

3-6. Repeat step 3-3 to 3-5 to enter up to 30 characters for message.

3-7. Press and hold the [ ] button for 2 seconds or longer to store the message in memory.

∗Press and hold the [BND] button for 1

second or longer to cancel the input message. Then press and hold the [ ] button for 2 seconds or longer to store the message and the message return to default setting.