Clarion DXZ575USB Operations Common to Each Mode, To change adjustment setting, Setting the clock

Operations Common to Each Mode

To change adjustment setting

1.Press and hold the [OPTION] button for 1 second or longer to switch to the adjustment selection display.

2.Push the [SEEK PANEL] leftward or rightward to select the “item name”.

“CLOCK” ↔ “CONTRAST” ↔ “SCRN SVR” ↔ “MESSAGE INPUT” ↔ “AUTO SCR” ↔ “SCRL SPD” ↔ “DIMMER” ↔ “BLINKLED” ↔ “A CANCEL” ↔ “TEL SP” ↔ “TEL SW” ↔ “SYSTEM CHECK” ↔ “CLOCK”...

3.Press the [UP] or [DN] button to select the “desired setting value”.

∗In the case of display blinking “ENT”, you

can press the [ ] button to adjust the setting value.

∗After completing settings, press the

[OPTION] button to return to the previous mode.

●Setting the clock

2-1.	Select “CLOCK”.
3-1.	Press the [	] button

3-2. Push the [SEEK PANEL] leftward or rightward to select the hour or the minute.

3-3. Press the [UP] or [DN] button to set the correct time.

∗The clock is displayed in 12-hour format.

3-4. Press the [	] button to store the
time into memory.

Note:

•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.

●Setting the contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “7”. (Adjustment level: 1 to 16)

2-1. Select “CONTRAST”.

3-1. Press the [UP] or [DN] button to adjust the contrast.

●Turning the screen saver function on

or off

This unit is provided with the screen saver function which allows you to show various kinds of patterns and characters in the operation status indication area of the display in a random order. You can turn on or off this function. If the button operation is performed with the screen saver function on, the operation display corresponding to the button operation is shown for about 30 seconds and the display returns to the screen saver display.

∗The factory default setting is “ON”.

2-1. Select “SCRN SVR”.

3-1. Press the [UP] or [DN] button to select “ON” or “OFF”.

●Entering message information

Message up to 30 characters long can be stored in memory and displayed as a type of screen saver setting.

∗The factory default setting is “WELCOME TO CLARION”.

2-1.	Select “MESSAGE INPUT”.
3-1.	Press the [	] button.

3-2. Press and hold the [MENU] button for 1 second or longer to clear the old message.

3-3. Push the [SEEK PANEL] leftward or rightward to move the cursor.

3-4 Press the [MENU] button to select a character type. Each time you press the [MENU] button, the character type changes in the following order:

Capital letters ➜ Numbers ➜ Symbols ➜ Capital letters…

3-5. Press the [UP] or [DN] button to select the desired character.

3-6. Repeat step 3-3 to 3-5 to enter up to 30 characters for message.

3-7. Press and hold the [ ] button for 2

seconds or longer to store the message in memory and return to the previous mode.

∗Press and hold the [MENU] button for 1 second or longer to cancel the input message. Then press and hold the

[ ] button for 2 seconds or longer to store the message and the message return to the default setting.

English

DXZ575USB 21