User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Mode | Global Config |
no snmptrap
This command deletes trap receivers for a community.
Format | no snmptrap <name> <ipaddr> |
Mode | Global Config |
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same IP address, the first entry is retained and processed. All duplicate entries are ignored.
Format | snmptrap ipaddr <name> <ipaddrold> <ipaddrnew> |
Mode | Global Config |
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format | snmptrap mode | <name> <ipaddr> |
Mode | Global Config |
|
no snmptrap mode |
|
|
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive traps).
Format | no snmptrap mode <name> <ipaddr> |
Mode | Global Config |
Switching Commands |
