NETGEAR 7300 Series user manual Mode-based Topology

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Table 7-1.	Command Mode (continued)
Command Mode		Access Method	Prompt	Exit or Access Next
				Mode
Router Config RIP		From the Global Config	Switch (Config-router)#	To exit to the Global
Mode		mode, enter the router		Config mode enter exit.
		rip command		To return to User Exec
				mode enter ctrl-Z.
DHCP Pool		From the Global	Routing (Config-dhcp-	To exit to Global
Configuration Mode		Configuration mode,	pool)	Configuration mode
		enter the ip dhcp pool		enter exit. To return to
		<pool-name>		user EXEC mode, enter
		command.		ctrl-Z

Mode-based Topology

The CLI tree is built on a mode concept where the commands are available according to the interface. Some of the modes are depicted in the mode-based CLI Figure 1.

Mode-based CLI 7-3

202-10009-01_060204