User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Neighbor Events | The number of times this neighbor relationship has changed state, |
| or an error has occurred. |
External LSA Count | The number of external (LS type 5) |
| the |
LSAs Received The number of LSAs received.
Originate New LSAs The number of LSAs originated.
show ip ospf neighbor
This command displays the OSPF neighbor table list. When a particular neighbor ID is specified, detailed information about a neighbor is given. The information below will only be displayed if OSPF is enabled and the interface has a neighbor. The IP address is the IP address of the neighbor.
Format | show ip ospf neighbor <ipaddr> <slot/port> |
Mode | Privileged EXEC and User EXEC |
Interface | Is the slot/port identifying the internal interface number of the |
| OSPF neighbor. |
Router Id | Is a |
Options | An integer value that indicates the optional OSPF capabilities |
| supported by the neighbor. The neighbor's optional OSPF capa- |
| bilities are also listed in its Hello packets. This enables received |
| Hello Packets to be rejected (i.e., neighbor relationships will not |
| even start to form) if there is a mismatch in certain crucial OSPF |
| capabilities. |
Router Priority | Displays the OSPF priority for the specified interface. The prior- |
| ity of an interface is a priority integer from 0 to 255. A value of '0' |
| indicates that the router is not eligible to become the designated |
| router on this network. |
State | The types are: |
| Down- initial state of the neighbor conversation - no recent infor- |
| mation has been received from the neighbor. |
| Attempt - no recent information has been received from the |
| neighbor but a more concerted effort should be made to contact |
| the neighbor. |
| Init - an Hello packet has recently been seen from the neighbor, |
| but |
| 2 way - communication between the two routers is |
|
|
Routing Commands |
