NETGEAR 7300 Series user manual Users passwd, Users snmpv3 accessmode, No users passwd

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

users passwd

This command changes the password of an existing operator. User password should not be more than eight characters in length. If a user is authorized for authentication or encryption is enabled, password must be eight alphanumeric characters in length. The username and password are not case-sensitive. When a password is changed, a prompt will ask for the operator’s former password. If none, press enter.

Default	No Password
Format	users passwd <username>
Mode	Global Config
no users passwd

This command sets the password of an existing operator to blank. When a password is changed, a prompt will ask for the operator's former password. If none, press enter.

Format	no users passwd <username>
Mode	Global Config

users snmpv3 accessmode

This command specifies the snmpv3 access privileges for the specified login user. The valid accessmode values are readonly or readwrite. The <username> is the login user name for which the specified access mode will apply.

Default	readwrite for admin user; readonly for all other users
Format	users snmpv3 accessmode <username> {readonly read-
	write}
Mode	Global Config

no users snmpv3 accessmode

This command sets the snmpv3 access privileges for the specified login user as readwrite for admin user; readonly for all other users. The <username> is the login user name for which the specified access mode will apply.

Format	no users snmpv3 accessmode <username>
Mode	Global Config
Switching Commands	8-93

202-10009-01_060204