![](/images/new-backgrounds/1110054/110054569x1.webp)
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
poe priority
This command sets the priority level for the delivery of power to an attached device. The switch may not be able to supply power to all connected devices, so the port priority is used to determine which ports will supply power if adequate power capacity is not available for all enabled ports. For ports that have the same priority level, the lower numbered port will have higher priority.
Default | low |
Format | poe priority <high/medium/low> |
Mode | Global Config |
poe limit
This command sets the power limit (in watts) for the port. The port will not supply more power than the value specified as the limit.
For the FSM7326P, the valid range is 3 - 18.
Default | 18 |
Format | poe limit |
Mode | Global Config |
poe usagethreshold
This command sets the power threshold level at which a trap will be generated. If the total power consumed is greater than or equal to the specified percentage of the total power available, a trap will be sent. The switch will continue to provide power even if the threshold is exceeded. The threshold value is for providing a warning. It does not interrupt the power. Valid values are 0 - 100.
Default | 80 |
Format | poe usagethreshold |
Mode | Global Config |
show poe port info
This command displays a summary for the ports that support the PoE function.
Format | show poe port <slot/port, All> |
|
Mode | Privilege |
|
|
| |
FSM7326P Power Over Ethernet Commands |