User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

 

 

 

copy <url> nvram:sshkey-dsa

Mode

Privileged EXEC

logout

This command closes the current telnet connection or resets the current serial connection.

Note: Save configuration changes before logging out.

Format

logout

Mode

Privileged EXEC

ping

This command checks if another computer is on the network and listens for connections. To use this command, configure the switch for network (in-band) connection (as described in the 7300 Series L3 Switch 2402/4802 Hardware User Guide). The source and target devices must have the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path between the switch and the workstation. The terminal interface sends, three pings to the target station.

Format

ping <ipaddr>

Mode

Privileged EXEC and User EXEC

reload

This command resets the switch without powering it off. Reset means that all network connections are terminated and the boot code executes. The switch uses the stored configuration to initialize the switch. You are prompted to confirm that the reset should proceed. A successful reset is indicated by the LEDs on the switch.

Format

reload

Mode

Privileged EXEC

Switching Commands

8-115

202-10009-01_060204

Page 181
Image 181
NETGEAR 7300 Series user manual Logout, Ping, Reload