NETGEAR 7300 Series user manual Storm-control broadcast, No storm-controlbroadcast

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Mode	Global Config
Acceptable values are:
100h	100BASE-T half-duplex
100f	100BASE-T full duplex
10h	10BASE-T half duplex
10f	100BASE-T full duplex

storm-control broadcast

This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm recovery with high and low thresholds is implemented.

The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or less. The full implementation is depicted in the “Broadcast Storm Recovery Thresholds” table.

Table 8-1.	Broadcast Storm Recovery Thresholds
Link Speed		High	Low
10M		20	10
100M		5	2
1000M		5	2
Format		switchconfig storm-control broadcast

Mode Global Covnfig

no storm-controlbroadcast

This command disables broadcast storm recovery mode.

The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or less. The full implementation is depicted in the “Broadcast Storm Recovery Thresholds” table.

Switching Commands 8-69

202-10009-01_060204