User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

 

38400,57600, and 115200 baud. The factory Default is 9600

 

baud.

Character Size

The number of bits in a character. The number of bits is always 8.

Flow Control

Whether Hardware Flow-Control is enabled or disabled. Hard-

 

ware Flow Control is always disabled.

Stop Bits

The number of Stop bits per character. The number of Stop bits is

 

always 1.

Parity Type

The Parity Method used on the Serial Port. The Parity Method is

 

always None.

show serviceport

This command displays service port configuration information.

Format

show serviceport

Mode

Privileged EXEC

IP Address

The IP address of the interface. The factory default value is

 

0.0.0.0

Subnet Mask

The IP subnet mask for this interface. The factory default value is

 

0.0.0.0

Default Gateway

The default gateway for this IP interface. The factory default

 

value is 0.0.0.0

ServPort Configuration Protocol Current Indicates what network protocol was used on the last, or current power-up cycle, if any.

Burned in MAC Address The burned in MAC address used for in-band connectivity.

show snmpcommunity

This command displays SNMP community information.

Six communities are supported. You can add, change, or delete communities. The switch does not have to be reset for changes to take effect.

The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community parameters).

8-26

Switching Commands

202-10009-01_060204

Page 92
Image 92
NETGEAR 7300 Series user manual Show serviceport, Show snmpcommunity