NETGEAR 7300 Series user manual Area virtual-link authentication, Area virtual-link dead-interval

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

area virtual-link authentication

This command configures the authentication type and key for the OSPF virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The value for <type> is either none, simple, or encrypt. The [key] is composed of standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key may be up to 256 bytes. Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a key id in the range of 0 and 255 must be specified.

Default	The default value for authentication type is none. Neither the
	default password key nor the default key id are configured.
Format	area <areaid> virtual-link <neighbor> authentication
Mode	{none {simple <key>} {encrypt <key> <keyid>}}
	Router OSPF Config

no area virtual-link authentication

This command configures the default authentication type for the OSPF virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.

Format	no area <areaid> virtual-link <neighbor> authentica-
Mode	tion
	Router OSPF Config

area virtual-link dead-interval

This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The range for <seconds> is 1 to 65535.

Default	40
Format	area <areaid> virtual-link <neighbor> dead-interval
Mode	<1-65535>
	Router OSPF Config

9-6 Routing Commands

202-10009-01_060204