
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as long as the session has been idle for the value set. A value of 0 indicates that a session remains active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is reaccessed. Any keystroke will also activate the new timeout duration.
Default | 5 |
Format | remotecon timeout |
Mode | Privileged EXEC |
no remotecon timeout |
|
This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is reaccessed. Any keystroke will also activate the new timeout duration.
Default | 5 |
Format | no remotecon timeout |
Mode | Privileged EXEC |
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default | 9600 |
Format | serial baudrate {1200 2400 4800 9600 19200 |
Mode | 38400 57600 115200} |
Line Config | |
no serial baudrate |
|
This command sets the communication rate of the terminal interface to 9600.
Format | no serial baudrate |
Mode | Line Config |
|
|
Switching Commands |