
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the applicable community name.
Format | no |
Mode | Global Config |
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated community SNMP packet sending address and is used along with the client IP address value to denote a range of IP addresses from which SNMP clients may use that community to access the device. A value of 255.255.255.255 will allow access from only one station, and will use that machine's IP address for the client IP Address. A value of 0.0.0.0 will allow access from any IP address. The name is the applicable community name.
Default | 0.0.0.0 |
Format | |
Mode | Global Config |
no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the applicable community name. The community name may be up to 16 alphanumeric characters.
Format | no |
Mode | Global Config |
snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP manager associated with this community manages the switch according to its access right. If the community is disabled, no SNMP requests using this community are accepted. In this case the SNMP manager associated with this community cannot manage the switch until the Status is changed back to Enable.
Default | The default private and public communities are enabled by |
| default. The four undefined communities are disabled by default. |
Format | |
|
|
Switching Commands |