User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
| successful attachment of a policy to the interface, or shall cause |
| this command to fail if the policy is already in service on one or |
| more interfaces. |
Policy Type | Out |
Incompatibilities | Expedite (all forms) |
bandwidth percent
This command identifies a minimum amount of bandwidth to be reserved for the specified class instance within the named policy using a relative rate notation. The committed information rate is specified as a percentage of total link capacity and is an integer from 1 to 100.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same bandwidth policy attribute.
Note: This command is only supported for GSM7324 and GSM7312.
Format | bandwidth percent |
Mode | |
Restrictions | The sum of the committed information rate values for all band- |
| width and expedite commands defined within a policy must not |
| exceed the available link bandwidth of the interface to which that |
| policy is assigned. Violation of this requirement shall prevent |
| successful attachment of a policy to the interface, or shall cause |
| this command to fail if the policy is already in service on one or |
| more interfaces. |
Policy Type | Out |
Incompatibilities | Expedite (all forms) |
class
This command creates an instance of a class definition within the specified policy for the purpose of defining treatment of the traffic class through subsequent policy attribute statements. The <classname> is the name of an existing DiffServ class. Note that this command causes the specified policy to create a reference to the class definition.
CLI Commands: Differentiated Services |
