User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

ip ospf cost

This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to 65535.

Default

10

Format

ip ospf cost <1-5535>

Mode

Interface Config

no ip ospf cost

 

This command configures the default cost on an OSPF interface. The <cost> parameter has a range of 1 to 65535.

Default

10

Format

no ip ospf cost

Mode

Interface Config

ip ospf dead-interval

This command sets the OSPF dead interval for the specified interface.

The value for <seconds> is a valid positive integer, which represents the length of time in seconds that a router's Hello packets have not been seen before its neighbor routers declare that the router is down. The value for the length of time must be the same for all routers attached to a common network. This value should be some multiple of the Hello Interval (i.e. 4).

Valid values range for <seconds> is from 1 to 2147483647.

Default

40

Format

ip ospf dead-interval <1-2147483647>

Mode

Interface Config

no ip ospf dead-interval

 

This command sets the default OSPF dead interval for the specified interface.

Format

no ip ospf dead-interval

Mode

Interface Config

 

 

9-26

Routing Commands

202-10009-01_060204

Page 208
Image 208
NETGEAR 7300 Series user manual Ip ospf cost, Ip ospf dead-interval, No ip ospf cost, No ip ospf dead-interval