
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Chapter 7
Mode-based CLI
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command modes are described below. Each of the command modes support specific 7300 Series L3 Switch commands.
•User Exec Mode
•Privileged Exec Mode
•Global Config Mode
•Vlan Mode
•Interface Config Mode
•Line Config Mode
•Policy Map Mode
•Policy Class Mode
•Class Map Mode
•Router Config OSPF Mode
•Router Config RIP Mode
•DHCP Pool Configuration Mode
The Command Mode table captures the command modes, the prompts visible in that mode and the exit method from that mode.
Table | Command Mode |
|
| ||
|
|
|
|
| |
Command Mode | Access Method | Prompt | Exit or Access Next | ||
Mode | |||||
|
|
|
| ||
|
|
|
| ||
User Exec Mode | This is the first level of | Switch> | Enter Logout command | ||
|
| access. Perform basic |
|
| |
|
| tasks and list system |
|
| |
|
| information. |
|
| |
|
|
|
| ||
Privileged Exec Mode | From the User Exec | Switch# | To exit this mode, enter | ||
|
| Mode, enter the enable |
| exit or press | |
|
| command. |
|
| |
|
|
|
|
| |
|
|