User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Format

no default-metric

Mode

Router RIP Config

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).

Default

Enabled

Format

enable

Mode

Router OSPF Config

no enable (OSPF)

 

This command sets the administrative mode of OSPF in the router to inactive.

Format

no enable

Mode

Router OSPF Config

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).

Default

Enabled

Format

enable

Mode

Router RIP Config

no enable (RIP)

 

This command sets the administrative mode of RIP in the router to inactive.

Format

no enable

Mode

Router RIP Config

distance ospf

This command sets the route preference value of OSPF in the router. Lower route preference values are preferred when determining the best route. The type of OSPF can be intra, inter, type-1, or type-2. The OSPF specification (RFC 2328) requires that preferences must be given to the routes learned via OSPF in the following order: intra < inter < type-1 < type-2.

9-16

Routing Commands

202-10009-01_060204

Page 198
Image 198
NETGEAR 7300 Series user manual Enable Ospf, Enable RIP, Distance ospf, No enable Ospf, No enable RIP