User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Total - A count of valid frames received which were discarded (i.e. filtered) by the forwarding process.

Local Traffic Frames - The total number of frames dropped in the forwarding process because the destination address was located off of this port.

802.3x Pause Frames Received - A count of MAC Control frames received on this interface with an opcode indicating the PAUSE operation. This counter does not increment when the interface is operating in half-duplex mode.

Unacceptable Frame Type - The number of frames discarded from this port due to being an unacceptable frame type.

VLAN Membership Mismatch - The number of frames dis- carded on this port due to ingress filtering.

VLAN Viable Discards - The number of frames discarded on this port when a lookup on a particular VLAN occurs while that entry in the VLAN table is being modified, or if the VLAN has not been configured.

Multicast Tree Viable Discards - The number of frames dis- carded when a lookup in the multicast tree for a VLAN occurs while that tree is being modified.

Reserved Address Discards - The number of frames discarded that are destined to an IEEE 802.1 reserved address and are not supported by the system.

Broadcast Storm Recovery - The number of frames discarded that are destined for FF:FF:FF:FF:FF:FF when Broadcast Storm Recovery is enabled.

CFI Discards - The number of frames discarded that have CFI bit set and the addresses in RIF are in non-canonical format.

Upstream Threshold - The number of frames discarded due to lack of cell descriptors available for that packet's priority level.

Packets Transmitted Octets

 

Total Bytes - The total number of octets of data (including those

 

in bad packets) received on the network (excluding framing bits

 

but including FCS octets). This object can be used as a reasonable

 

estimate of ethernet utilization. If greater precision is desired, the

 

etherStatsPkts and etherStatsOctets objects should be sampled

 

before and after a common interval. -----

 

 

Switching Commands

8-7

202-10009-01_060204

Page 73
Image 73
NETGEAR 7300 Series user manual Packets Transmitted Octets