User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
OSPF Admin Mode | The administrative mode of OSPF in the router. This is a config- |
| ured value. |
ASBR Mode | Reflects whether the ASBR mode is enabled or disabled. Enable |
| implies that the router is an autonomous system border router. |
| Router automatically becomes an ASBR when it is configured to |
| redistribute routes learnt from other protocol. The possible values |
| for the ASBR status is enabled (if the router is configured to re- |
| distribute routes learnt by other protocols) or disabled (if the |
| router is not configured for the same). |
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled. This
| is a configured value. |
| RDefault value for redistributed routes. |
Source | Source protocol/routes that are being redistributed. |
| Metric of the routes being redistributed. |
| The criteria by which OSPF routes are redistributed into other |
| routing domains. |
| External Type 1 or External Type 2 routes. |
| Decimal value attached to each external route. |
Subnets | For redistributing routes into OSPF, the scope of redistribution |
| for the specified protocol. |
| TAccess list used to filter redistributed routes. |
| Indicates whether the default routes received from other source |
| protocols are advertised or not |
The information below will only be displayed if OSPF is enabled. | |
ABR Status | Reflects the whether or not the router is an OSPF Area Border |
| Router. |
Exit Overflow Interval | The number of seconds that, after entering OverflowState, a |
| router will attempt to leave OverflowState. |
External LSA count | The number of external (LS type 5) |
| the |
External LSA Checksum A number which represents the sum of the LS checksums of external
Routing Commands |