NETGEAR 7300 Series user manual Hardware-address, Host, No hardware-address, No host

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

hardware-address

This command specifies the hardware address of a DHCP client.

Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes in dotted hexadecimal format.

Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE 802.

Default	Ethernet
Format	hardware-address <hardwareaddress> [type]
Mode	DHCP Pool Config Mode
no hardware-address

This command removes the hardware address of the DHCP client.

Format	no hardware-address
Mode	DHCP Pool Config Mode

host

This command specifies the IP address and network mask for a manual binding to a DHCP client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.

The prefix-length is an integer from 0 to 32

Default	None
Format	host <address> [mask prefix-length]
Mode	DHCP Pool Config Mode
no host

This command removes the IP address of the DHCP client.

Format	no host
Mode	DHCP Pool Config Mode

DHCP Server Commands 12-3

202-10009-01_060204