
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
radius server key
This command is used to configure the shared secret between the RADIUS client and the RADIUS accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the shared secret will be configured for the RADIUS authentication or RADIUS accounting server. The IP address provided must match a previously configured server. When this command is executed, the secret will be prompted. The secret must be an alphanumeric value not exceeding 20 characters.
Format | radius server key {auth acct} <ipaddr> |
Mode | Global Config |
radius server msgauth
This command enables the message authenticator attribute for a specifiedserver.
Default | radius | server | msgauth <ipaddr> |
Mode | Global | Config |
|
radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS client. The primary server is the one that is used by default for handling RADIUS requests. The remaining configured servers are only used if the primary server cannot be reached. A maximum of three servers can be configured on each client. Only one of these servers can be configured as the primary. If a primary server is already configured prior to this command being executed, the server specified by the IP address specified used in this command will become the new primary server. The IP address must match that of a previously configured RADIUS authentication server.
Format | radius server primary <ipaddr> |
Mode | Global Config |
radius server retransmit
This command sets the maximum number of times a request packet is
Default10
Switching Commands |