NETGEAR 7300 Series user manual Snmp trap link-status all, Spanning-tree

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Mode Interface Config

snmp trap link-status all

This command enables link status traps for all interfaces.

Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server enable traps linkmode”).

Format	snmp trap link-status all
Mode	Global Config

no snmp trap link-status all

This command disables link status traps for all interfaces.

Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server enable traps linkmode”).

Format	no snmp trap link-status all
Mode	Global Config

spanning-tree

This command sets the STP mode for a specific port-channel (LAG). This is the value specified for STP Mode on the Port Configuration Menu. 802.1D mode is the default. The interface is a logical slot and port for a configured port-channel. The all option sets all configured port- channels (LAGs) with the same option.

Format	spanning-tree		{<logical slot/port> all} {off
	802.1d	fast}
Mode	Global	Config

The mode is one of the following:

802.1d	IEEE 802.1D-compliant STP mode is used
fast	Fast STP mode is used
off	STP is turned off

Switching Commands 8-67

202-10009-01_060204