User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Mode

Global Config

dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on this port. Depending on the token used and the value (in seconds) passed, various timeout configurable parameters are set. The following tokens are supported.

reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to determine when re-authentication of the supplicant takes place. The reauth-period must be a value in the range 1 - 65535.

quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to define periods of time in which it will not attempt to acquire a supplicant. The quiet- period must be a value in the range 0 - 65535.

tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must be a value in the range 1 - 65535.

supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.

server-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to timeout the authentication server. The supp-timeout must be a value in the range 1 - 65535.

Default

reauth-period: 3600 seconds

 

quiet-period: 60 seconds

 

tx-period: 30 seconds

 

supp-timeout: 30 seconds

 

server-timeout: 30 seconds

Format

dot1x timeout {{reauth-period <seconds>} {quiet-period <sec-

 

onds>} {tx-period <seconds>} {supp-timeout <seconds>}

 

{server-timeout <seconds>}}

Mode

Interface Config

8-100

Switching Commands

202-10009-01_060204

Page 166
Image 166
NETGEAR 7300 Series user manual Dot1x timeout