User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

Status

A pull down menu that indicates the receiver's status(enabled or

 

disabled) and allows the administrator/user to perform actions on

 

this user entry:

 

Enable - send traps to the receiver

 

Disable - do not send traps to the receiver.

 

Delete - remove the table entry.

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to implement the changes. Cold and warm start traps are always generated and cannot be disabled.

Format

show trapflags

Mode

Privileged EXEC

Authentication Flag

May be enabled or disabled. The factory default is enabled. Indi-

 

cates whether authentication failure traps will be sent.

Link Up/Down Flag

May be enabled or disabled. The factory default is enabled. Indi-

 

cates whether link status traps will be sent. Multiple Users Flag.

Multiple Users Flag

May be enabled or disabled. The factory default is enabled. Indi-

 

cates whether a trap will be sent when the same user ID is logged

 

into the switch more than once at the same time (either via telnet

 

or serial port).

Spanning Tree Flag

May be enabled or disabled. The factory default is enabled. Indi-

 

cates whether spanning tree traps will be sent.

Broadcast Storm Flag

May be enabled or disabled. The factory default is enabled. Indi-

 

cates whether broadcast storm traps will be sent.

DVMRP Traps

May be enabled or disabled. The factory default is disabled. Indi-

 

cates whether DVMRP traps will be sent.

OSPF Traps

May be enabled or disabled. The factory default is disabled. Indi-

 

cates whether OSPF traps will be sent.

PIM Traps

May be enabled or disabled. The factory default is disabled. Indi-

 

cates whether PIM traps will be sent.

8-28

Switching Commands

202-10009-01_060204

Page 94
Image 94
NETGEAR 7300 Series user manual Show trapflags