User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2, both to receive packets from either format, or none to not allow any RIP control packets to be received.
Default | both |
Format | ip rip receive version {rip1 rip2 both none} |
Mode | Interface Config |
no ip rip receive version |
|
This command configures the interface to allow RIP control packets of the default version(s) to be received.
Format | no ip rip | receive version |
Mode | Interface | Config |
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default | rip1c |
Format | ip rip send version {rip1 rip1c rip2 none} |
Mode | Interface Config |
no ip rip send version |
|
This command configures the interface to allow RIP control packets of the default version to be sent.
Format | no ip rip | send version |
Mode | Interface | Config |
|
|
|
| Routing Commands |
