WIRING DIAGRAM
NOTE: #PESBR084 Blower Motor Rating: 120 volts/60HZ/1.1 Amps.
NOTE: For convenience, allow licensed electrician to install properly grounded
MOTOR
JUMPERTHERMOSTAT
JUMPER
GREEN
JUMPER
WHITE
BLACK
RHEOSTAT
POWER CORD
BLACK 
NOTE: “If any of the original wire as supplied with the gas appliance must be replaced, it must be replaced with a wire of at least a 105o C. temperature rating.”
NOTE: Installation and repair should be done by a qualified service person. This heater should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments and circulating air passageways of the heater be kept clean.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Page 28
