User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

no area virtual-link dead-interval

This command configures the default dead interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.

Format

no area <areaid> virtual-link <neighbor> dead-inter-

Mode

val

Router OSPF Config

area virtual-link hello-interval

This command configures the hello interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The range for <seconds> is 1 to 65535.

Default

10

Format

area <areaid> virtual-link <neighbor> hello-interval

Mode

<1-65535>

Router OSPF Config

no area virtual-link hello-interval

This command configures the default hello interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.

Format

no area <areaid> virtual-link <neighbor> hello-inter-

Mode

val

Router OSPF Config

area virtual-link retransmit-interval

This command configures the retransmit interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The range for <seconds> is 0 to 3600.

Default

5

Format

area <areaid> virtual-link <neighbor> retransmit-

 

interval <0-3600>

 

 

Routing Commands

9-7

202-10009-01_060204

Page 189
Image 189
NETGEAR 7300 Series user manual Area virtual-link hello-interval, Area virtual-link retransmit-interval