User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-16 Switching Commands
202-10009-01_060204
Dot1P Commands

classofservice dot1pmapping

This command maps an 802.1p priority to an internal traffic class for a device when in ‘Global
Config’ mode. The number of available traffic classes may vary with the platform. Userpriority
and trafficclass can both be the range from 1-7. Under ‘Interface Config’ mode, this command
maps an 802.1p priority to an internal traffic class for a specific interface. The command (in either
modes) is only available on platforms that support priority to traffic class mapping on a ‘per-port’
basis, and the number of available traffic classes may vary with the platform.
Format classofservice dot1pmapping <userpriority> <traffic-
class>
Mode Global Config or Interface Config

show classofservice dot1pmapping

This command displays the current 802.1p priority mapping to internal traffic classes for a specific
interface. The slot/port parameter is required on platforms that support priority to traffic class
mapping on a ‘per-port’ basis.
Platforms that support priority to traffic class mapping on a per-port basis:
Format show classofservice dot1pmapping <slot/port>
Platforms that do not support priority to traffic class mapping on a per-port basis:
Format show classofservice dot1pmapping
Mode Privileged EXEC and User EXEC

vlan port priority all

This command configures the port priority assigned for untagged packets for all ports presently
plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration
will override this configuration setting.
Format vlan port priority all <priority>
Mode Global Config